Back to Blog
Alpha 1 bellows installation5/30/2023 ![]() At the same time, the paint can top will be pushed back into the bellows. When you have about 1/4 to 1/8 inch left before the paint can top pulls through bellows you will be able to insert the retainer ring and press it into place. This will expand the bellows against the bell-housing. Be careful not to pull the top all the way through the bellows. Now using a pliers start to pull the paint can top through the bellows keeping it perpendicular to the bellow sides. The reason you can't install the retainer ring is because with the bellows in the housing the edge of the bellows edge tips in and you can't start the retainer ring. The paint can will be inside the bellows. Now install the bell-housing onto the bellows. Now place the paint can top inside the bellows. You will be pulling on these screws later. drill three holes in a triangle pattern in the paint can top and install a metal screw into each hole. I found that the top of a one quart paint can just fits into the inside of the bellows, bell-housing side. ![]() install the water hose to transom and to bell-housing. ![]() ![]() Glue bellows to the back of the transom and secure with hose clamp.ģ. If I have to do this again this will be my procedure.ġ.
0 Comments
Read More
Leave a Reply. |